3Com 3C13636 Configuration Manual page 362

3Com Router 3000 Ethernet Family
Configuration Guide
Table 3-7 Configure bridging on HDLC
Apply a bridge-set on the HDLC interface.
V. Configuring bridging on X.25
In setting up a bridge, you need to map the bridge address to the X.121 address of
X.25.
Perform the following configuration in X.25 interface view.
Table 3-8 Configure a bridge address to X.121 map entry
Apply a bridge-set on the X.25 interface.
Configure a bridge-set to X.25 map
entry.
Delete a map entry.
VI. Configuring bridging on frame relay
In setting up a bridge, you need to map the bridge address to DLCI.
Perform the following configuration in frame relay interface view.
Table 3-9 Configure a bridge address to DLCI map entry
Apply a bridge-set on the frame relay
interface.
Configure a bridge-set to frame relay map
entry.
Delete a map entry.
VII. Configuring bridging on ATM
Bridging on VLAN uses the same spanning tree algorithm adopted by bridging on
other protocols. When setting up a bridge, you only need to add the bridging function
to the ATM interface after you configure a PVC.
Operation
Operation
Operation
3Com Corporation
3-13
Chapter 3 Bridge Configuration
Command
bridge-set bridge-set
Command
bridge-set bridge-set
x25 map bridge
x.121-address broadcast
undo x25 map bridge x121-address
x.121-address
Command
bridge-set bridge-set
fr map bridge dlci broadcast
undo fr map bridge dlci
x121-address