About Fibre Channel Routes; Configuring Fibre Channel Routes - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

FSPF Routes
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

About Fibre Channel Routes

Each port implements forwarding logic, which forwards frames based on its FC ID. Using the FC ID for
the specified interface and domain, you can configure the specified route (for example FC ID 111211
and domain ID 3) in the switch with domain ID 1 (see
Figure 25-4
Domain ID 1
Other than in VSANs, runtime checks are not performed on configured and suspended static routes.
Note

Configuring Fibre Channel Routes

To configure a Fibre Channel route, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Cisco MDS 9000 Family CLI Configuration Guide
25-10
Fibre Channel Routes
fc1/1
Domain ID 3
FC ID 111211
Chapter 25 Configuring Fibre Channel Routing Services and Protocols
Figure 25-4).
Domain ID 7
Purpose
Enters configuration mode.
OL-16184-01, Cisco MDS SAN-OS Release 3.x