Upgrading A Loader - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 7 Software Images
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
Verify that the file was copied in the required directory.
Step 4
switch# dir bootflash:
40295206
12456448
12288
27602159
12447232
28364853
Usage for bootflash://sup-local
135404544 bytes used
49155072 bytes free
184559616 bytes total
Ensure that the software images are not damaged or corrupted in the saved bootflash: file system.
Step 5
When copying a new image to your switch, confirm that the image was not corrupted during the copy
process.
Use the show version image command to verify that the required image was copied successfully.
switch# show version image bootflash:kickstart-image
image name: m9500-sf1ek9-kickstart-mzg.1.0.3.bin
kickstart:
loader:
compiled:
Note
Step 6 Compare the running system image and the new image by issuing the show install all impact command.

Upgrading a Loader

The install module slot# of the supervisor module loader command upgrades the (boot) loader.
If the loader is upgraded, you need to reboot to make the new loader effective. You can schedule the
Note
reboot at a convenient time so traffic is not impacted.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
The Cisco MDS 9216 Switch does not have an external CompactFlash (see the
Note
Configuration Files" section on page
bootflash: file system to copy and verify files.
CompactFlash device—Copy the software image file from the appropriate SCP file system to the
CompactFlash device in slot0: file system.
switch# copy scp://server_IP_address/file_name_in_SCP slot0:system-image
You can also copy the image onto a new Flash disk from a PC and insert it in slot0: in the Cisco
MDS 9500 Series switch. After you copy the image and insert it into the slot0: file system, the
process is the same as the CompactFlash device after the copy command is issued.
Aug 05 15:23:51 1980
Jul 30 23:05:28 1980
Jun 23 14:58:44 1980
Jul 30 23:05:16 1980
Aug 05 15:08:30 1980
Aug 05 15:11:57 1980
version 1.0(3)
version 1.0(3)
2/12/2003 11:00:00
A verification failed message is generated when you use a Cisco MDS 9500 Series image on a
Cisco MDS 9200 Series switch or a Cisco MDS 9200 Series image on a Cisco MDS 9500 Series
switch. Be sure to verify the right image.
Manual Upgrade on a Dual Supervisor Module Switch
8-1). If you are using a switch in this series, use the
ilc1.bin
kickstart-image1
lost+found/
system-image1
kickstart-image2
system-image2
Cisco MDS 9000 Family CLI Configuration Guide
"Managing
7-27