Configuring Ivr Virtual Domains; Verifying The Ivr Virtual Domain Configuration; Clearing The Ivr Fcdomain Database; About Persistent Fc Ids For Ivr - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Cisco mds 9000 family cli configuration guide, release 3.x (ol-16184-01, april 2008)
Hide thumbs Also See for Cisco MDS 9020 - Fabric Switch:
Table of Contents

Advertisement

Configuring IVR
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Withdrawing an overlapping virtual domain from an IVR VSAN disrupts IVR traffic to and from that
Note
domain.
Use the ivr withdraw domain command in EXEC mode to temporarily withdraw the overlapping virtual
domain interfaces from the affected VSAN.
Only add IVR domains in the edge VSANs and not in transit VSANs.
Tip

Configuring IVR Virtual Domains

To configure an IVR virtual domain in a specified VSAN, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ivr virtual-fcdomain-add
vsan-ranges 1
switch(config)# no ivr virtual-fcdomain-add
vsan-ranges 1

Verifying the IVR Virtual Domain Configuration

View the status of the IVR virtual domain configuration using the show ivr
virtual-fcdomain-add-status command.
switch# show ivr virtual-fcdomain-add-status
IVR virtual domains are added to fcdomain list in VSANS: 1
(As well as to VSANs in interoperability mode 2 or 3)

Clearing the IVR fcdomain Database

You might want to clear the IVR fcdomain database. You can do this using the following command:
switch# clear ivr fcdomain database

About Persistent FC IDs for IVR

You can configure persistent FC IDs for IVR. FC ID persistence across reboot improves IVR
management by providing the following features:
The benefits of persistent FC IDs for IVR are as follows:
Cisco MDS 9000 Family CLI Configuration Guide
22-24
Allows you to control and assign a specific virtual domain to use for a native VSAN.
Allows you to control and assign a specific virtual FC ID to use for a device.
Chapter 22
Configuring Inter-VSAN Routing
Purpose
Enters configuration mode.
Adds the IVR virtual domains in VSAN 1.
Reverts to the factory default of not adding IVR
virtual domains and removes the currently
active virtual domains for that VSAN from the
fcdomain manger list
OL-16184-01, Cisco MDS SAN-OS Release 3.x

Advertisement

Table of Contents
loading

Table of Contents