Configuring Server Groups - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 32 Configuring RADIUS and TACACS+
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Example 32-9 Displays All AAA Server Groups
switch# show aaa groups
radius
TacServer
Example 32-10 Displays TACACS+ Server Statistics
switch# show tacacs-server statistics 10.1.2.3
Server is not monitored
Authentication Statistics
Authorization Statistics
Accounting Statistics

Configuring Server Groups

You can specify one or more remote AAA servers to authenticate users using server groups. All members
of a group must belong to the same protocol, either RADIUS or TACACS+. The servers are tried in the
same order in which you configure them.
The AAA server monitoring feature can mark an AAA server as dead. You can configure a period of time
in minutes to elapse before the switch sends requests to a dead AAA server. (See the
Monitoring" section on page
You can configure these server groups at any time but they only take effect when you apply them to an
AAA service. You configure AAA policies for CLI users or Fabric Manager or Device Manager users.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
failed transactions: 0
sucessfull transactions: 0
requests sent: 0
requests timed out: 0
responses with no matching requests: 0
responses not processed: 0
responses containing errors: 0
failed transactions: 0
sucessfull transactions: 0
requests sent: 0
requests timed out: 0
responses with no matching requests: 0
responses not processed: 0
responses containing errors: 0
failed transactions: 0
sucessfull transactions: 0
requests sent: 0
requests timed out: 0
responses with no matching requests: 0
responses not processed: 0
responses containing errors: 0
32-5.)
Configuring Server Groups
Cisco MDS 9000 Family CLI Configuration Guide
"AAA Server
32-27