HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 253

Cisco mds 9000 family cli configuration guide, release 3.x (ol-16184-01, april 2008)
Hide thumbs Also See for Cisco MDS 9020 - Fabric Switch:
Table of Contents

Advertisement

Chapter 7
Software Images
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Remove the Supervisor-1 module from the chassis.
Step 18
Set the baud rate on the active Supervisor-2 module console session to the default value of 9600.
Step 19
switch# config t
switch(config)# line console
switch(config-console)# speed 9600
switch(config-console)# end
switch# show line console
line Console:
Speed:
Databits:
Stopbits:
Parity:
Modem In: Disable
Modem Init-String -
Step 20
Install the other Supervisor-2 module in the chassis..
Step 21
Configure the boot for the Supervisor-2 module.
switch# config t
switch(config)# boot kickstart bootflash:kickstart-img
switch(config)# boot kickstart bootflash:system-img
switch(config)# end
switch#
Save the configuration.
Step 22
switch# copy running-config startup-config
[########################################] 100%
switch#
Verify that the standby Supervisor-2 module is in the HA standby state.
Step 23
switch# show system redundancy status
Redundancy mode
---------------
This supervisor (sup-1)
-----------------------
Redundancy state:
Supervisor state:
Other supervisor (sup-2)
------------------------
Redundancy state:
Supervisor state:
If the Cisco MDS SAN-OS system image on the supervisor modules is the desired release, enter the
Step 24
install all command.
switch# install all
If you want a different release of the Cisco SAN-OS system image running on the switch, enter the
install all command specifying the system image to perform a hitless upgrade (see the
Upgrades" section on page
switch# install all system tftp://10.16.10.100/system-img
OL-16184-01, Cisco MDS SAN-OS Release 3.x
9600 bauds
8 bits per byte
1 bit(s)
none
default : ATQ0V1H0S0=1\015
administrative:
HA
operational:
HA
Active
Active
Internal state:
Active with HA standby
Standby
HA standby
Internal state:
HA standby
7-6).
Maintaining Supervisor Modules
Cisco MDS 9000 Family CLI Configuration Guide
"Automated
7-39

Advertisement

Table of Contents
loading

Table of Contents