Configuring Islb Initiator Names Or Ip Addresses - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Configuring iSLB
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
•
•
•
•
•

Configuring iSLB Initiator Names or IP Addresses

You must specify the iSLB initiator name or IP address before configuring it.
Specifying the iSLB initiator name or IP address is the same as for an iSCSI initiator. See the
Note
Mapping" section on page
To enter iSLB initiator configuration submode using the name option for an iSLB initiator, follow these
steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# islb initiator name
iqn.1987-02.com.cisco.initiator
switch(config-islb-init)#
switch(config)# no lslb initiator name
iqn.1987-02.com.cisco.initiator
To enter iSLB initiator configuration submode using the ip-address option for an iSLB initiator, follow
these steps:
Command
Step 1
switch# config terminal
switch(config)#
Step 2
switch(config)# islb initiator
ip-address 10.1.1.3
switch(config-islb-init)#
switch(config)# no islb initiator
ip-address 10.1.1.3
switch(config)# islb initiator
ip-address 2001:0DB8:800:200C::417A
switch(config-islb-init)#
switch(config)# no islb initiator
ip-address 2001:0DB8:800:200C::417A
Cisco MDS 9000 Family CLI Configuration Guide
42-42
Assigning VSAN Membership for iSLB Initiators, page 42-44
Configuring Metric for Load Balancing, page 42-45
Verifying iSLB Initiator Configuration, page 42-45
Verifying iSLB Authentication Configuration, page 42-49
Configuring and Activating Zones for iSLB Initiators and Initiator Targets, page 42-46
Configuring iSLB Session Authentication, page 42-48
Verifying iSLB Authentication Configuration, page 42-49
42-13.
Purpose
Enters configuration mode.
Configures an iSLB initiator using the iSCSI name of
the initiator node (iqn.1987-02.com.cisco.initiator) and
enters iSLB initiator configuration submode. The
maximum name length is 223 alphanumeric characters.
The minimum length is 16.
Deletes the configured iSLB initiator.
Purpose
Enters configuration mode.
Configures an iSLB initiator using the IPv4 address of
the initiator node and enters iSLB initiator configuration
submode.
Deletes the configured iSLB initiator.
Configures an iSLB initiator using the IPv6 unicast
address of the initiator node and enters iSLB initiator
configuration submode.
Deletes the configured iSLB initiator.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 42 Configuring iSCSI
"Static