HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 168

Initial Setup Routine
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Enter the IPv4 subnet mask.
VSAN1 IPv4 net mask: subnet_mask
Enter no (yes is the default) to enable IPv4 routing capabilities.
b.
Enable ip routing capabilities? (yes/no) [y]: no
Enter no (yes is the default) to configure a static route.
c.
Configure static route: (yes/no) [y]: no
d. Enter no (yes is the default) to configure the default network.
Configure the default-network: (yes/no) [y]: no
e. Enter no (yes is the default) to configure the DNS IPv4 address.
Configure the DNS IP address? (yes/no) [y]: no
Enter no (no is the default) to skip the default domain name configuration.
f.
Configure the default domain name? (yes/no) [n]: no
Enter no (yes is the default) to disable the Telnet service.
Step 10
Enable the telnet service? (yes/no) [y]: no
Enter yes (no is the default) to enable the SSH service.
Step 11
Enabled SSH service? (yes/no) [n]: yes
Enter the SSH key type (see the
Step 12
would like to generate.
Type the SSH key you would like to generate (dsa/rsa/rsa1)? rsa
Enter the number of key bits within the specified range.
Step 13
Enter the number of key bits? (768 to 1024): 1024
Enter no (no is the default) to configure the NTP server.
Step 14
Configure NTP server? (yes/no) [n]: no
Enter shut (shut is the default) to configure the default switch port interface to the shut (disabled) state.
Step 15
Configure default switchport interface state (shut/noshut) [shut]: shut
Note
Enter auto (off is the default) to configure the switch port trunk mode.
Step 16
Configure default switchport trunk mode (on/off/auto) [off]: auto
Enter yes (yes is the default) to configure the switchport mode F.
Step 17
Configure default switchport mode F (yes/no) [n]: y
Enter off (off is the default) to configure the PortChannel auto-create state.
Step 18
Configure default port-channel auto-create state (on/off) [off]: off
Cisco MDS 9000 Family CLI Configuration Guide
5-12
"Overwriting a Generated Key Pair" section on page
The management Ethernet interface is not shut down at this point—only the Fibre Channel,
iSCSI, FCIP, and Gigabit Ethernet interfaces are shut down.
Chapter 5 Initial Configuration
39-17that you
OL-16184-01, Cisco MDS SAN-OS Release 3.x