Using The Setup Command - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 5 Initial Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Enter deny (deny is the default) to deny a default zone policy configuration.
Step 19
Configure default zone policy (permit/deny) [deny]: deny
Denies traffic flow to all members of the default zone.
Enter no (no is the default) to disable a full zone set distribution (see the
Step 20
on page
Enable full zoneset distribution (yes/no) [n]: no
Disables the switch-wide default for the full zone set distribution feature.
You see the new configuration. Review and edit the configuration that you have just entered.
Enter no (no is the default) if you are satisfied with the configuration.
Step 21
The following configuration will be applied:
username admin password admin_pass role network-admin
snmp-server community snmp_community rw
switchname switch
interface vsan1
ip default-gateway default_gateway
no telnet server enable
ssh key rsa 1024 force
ssh server enable
system default switchport shutdown
system default switchport trunk mode auto
system default switchport mode F
no zone default-zone permit vsan 1-4093
no zoneset distribute full vsan 1-4093
Would you like to edit the configuration? (yes/no) [n]: no
Enter yes (yes is default) to use and save this configuration.
Step 22
Use this configuration and save it? (yes/no) [y]: yes
Caution

Using the setup Command

To make changes to the initial configuration at a later time, you can issue the setup command in EXEC
mode.
switch# setup
---- Basic System Configuration Dialog ----
This setup utility will guide you through the basic configuration of
the system. Setup configures only enough connectivity for management
of the system.
*Note: setup always assumes a predefined defaults irrespective
of the current system configuration when invoked from CLI.
Press Enter incase you want to skip any dialog. Use ctrl-c at anytime
to skip away remaining dialogs.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
23-13).
ip address ip_address subnet_mask
no shutdown
If you do not save the configuration at this point, none of your changes are updated the next
time the switch is rebooted. Type yes to save the new configuration. This ensures that the
kickstart and system images are also automatically configured (see
Images").
"Zone Set Distribution" section
Chapter 7, "Software
Cisco MDS 9000 Family CLI Configuration Guide
Initial Setup Routine
5-13