HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 164

Cisco mds 9000 family cli configuration guide, release 3.x (ol-16184-01, april 2008)
Hide thumbs Also See for Cisco MDS 9020 - Fabric Switch:
Table of Contents

Advertisement

Initial Setup Routine
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Enable the ip routing? (yes/no) [y]: yes
Enter yes (yes is the default) to configure a static route (recommended).
c.
Configure static route: (yes/no) [y]: yes
Enter the destination prefix.
Destination prefix: dest_prefix
Type the destination prefix mask.
Destination prefix mask: dest_mask
Type the next hop IP address.
Next hop ip address: next_hop_address
Note
d.
Enter yes (yes is the default) to configure the default network (recommended).
Configure the default network: (yes/no) [y]: yes
Enter the default network IPv4 address.
Note
Default network IP address [dest_prefix]: dest_prefix
Enter yes (yes is the default) to configure the DNS IPv4 address.
e.
Configure the DNS IP address? (yes/no) [y]: yes
Enter the DNS IP address.
DNS IP address: name_server
Enter yes (default is no) to configure the default domain name.
f.
Configure the default domain name? (yes/no) [n]: yes
Enter the default domain name.
Default domain name: domain_name
Enter yes (yes is the default) to enable the Telnet service.
Step 12
Enable the telnet service? (yes/no) [y]: yes
Step 13
Enter yes (no is the default) to enable the SSH service.
Enabled SSH service? (yes/no) [n]: yes
Step 14
Enter the SSH key type (see the
would like to generate.
Type the SSH key you would like to generate (dsa/rsa/rsa1)? dsa
Cisco MDS 9000 Family CLI Configuration Guide
5-8
Be sure to configure the IP route, the default network IP address, and the default gateway IP
address to enable SNMP access. If IP routing is enabled, the switch uses the IP route and the
default network IP address. If IP routing is disabled, the switch uses the default gateway IP
address.
The default network IPv4 address is the destination prefix provided in
"Overwriting a Generated Key-Pair" section on page
Chapter 5
Initial Configuration
Step 11c
39-16) that you
OL-16184-01, Cisco MDS SAN-OS Release 3.x
.

Advertisement

Table of Contents
loading

Table of Contents