Removing An Application From A Region; Deleting Cfs Regions; Default Settings - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 6 Using the CFS Infrastructure
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Removing an Application from a Region

Removing an application from a region is the same as moving the application back to the default region
or to Region 0, that is, bringing the entire fabric into the scope of distribution for the application.
To remove applications from Region 1, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# cfs region 1
Step 3
switch(config-cfs-region)# no ntp
switch(config-cfs-region)# no callhome

Deleting CFS Regions

Deleting a region is nullifying the region definition. All the applications bound by the region are released
back to the default region by deleting that region.
To delete a region, for example, a region numbered 4, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# no cfs region 4
WARNING: All applications in the region
wiil be
Are you sure? (y/n)
Note After Step 2, you see the warning, "All the applications in the region will be moved to the default region."

Default Settings

Table 6-1
Table 6-1
Parameters
CFS distribution on the switch
Database changes
Application distribution
Commit
CFS over IP
IPv4 multicast address
IPv6 multicast address
OL-16184-01, Cisco MDS SAN-OS Release 3.x
moved to default region.
[n]
lists the default settings for CFS configurations.
Default CFS Parameters
Default
Enabled.
Implicitly enabled with the first configuration change.
Differs based on application.
Explicit configuration is required.
Disabled.
239.255.70.83
ff15::efff:4653
Purpose
Enters configuration mode.
Enters the Region 1.
Removes application(s) that belong to Region 1,
which you want to move.
Purpose
Enters configuration mode.
Deletes the Region 4.
Cisco MDS 9000 Family CLI Configuration Guide
Default Settings
6-17