Verifying Cloud Discovery Status; Verifying Cloud Discovery Membership; Displaying Cloud Discovery Statistics; Default Settings - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Default Settings

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To configure iSNS cloud discovery message types, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# cloud discovery message
icmp

Verifying Cloud Discovery Status

Use the show cloud discovery status command to verify the status of the cloud discovery operation.
switch# show cloud discovery status
Discovery status: Succeeded

Verifying Cloud Discovery Membership

Use the show cloud membership all command to verify the cloud membership for the switch.
switch# show cloud membership all
Cloud 2
#members=2
Use the show cloud membership unresolved command to verify the unresolved membership on the
switch.
switch# show cloud membership unresolved
Undiscovered Cloud
No members

Displaying Cloud Discovery Statistics

Use the show cloud discovery statistics command to display the statistics for the cloud discovery
operation.
switch# show cloud discovery statistics
Global statistics
Default Settings
Table 42-2
Cisco MDS 9000 Family CLI Configuration Guide
42-96
GigabitEthernet1/5[20:00:00:0d:ec:02:c6:c0] IP Addr 10.10.10.5
GigabitEthernet1/6[20:00:00:0d:ec:02:c6:c0] IP Addr 10.10.10.6
Number of Auto Discovery
Number of Manual Discovery
Number of cloud discovery (ping) messages sent = 1
Number of cloud discovery (ping) success
lists the default settings for iSCSI parameters.
Chapter 42
Purpose
Enters configuration mode.
Enables (default) iSNS cloud discovery using
ICMP messages.
Only ICMP messages are supported.
Note
= 1
= 0
= 1
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Configuring iSCSI