Disabling Fspf For Specific Interfaces; Clearing Fspf Counters For An Interface; Fspf Routes - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 25 Configuring Fibre Channel Routing Services and Protocols
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
FSPF must be enabled at both ends of the interface for the protocol to work.
Note

Disabling FSPF for Specific Interfaces

You can disable the FSPF protocol for selected interfaces. By default, FSPF is enabled on all E ports and
TE ports. This default can be disabled by setting the interface as passive.
To disable FSPF for a specific interface, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# interface fc1/4
switch(config-if)#
Step 3
switch(config-if)# fspf passive vsan 1
switch(config-if)#
switch(config-if)# no fspf passive vsan 1
switch(config-if)#
You can disable the FSPF protocol for selected interfaces. By default, FSPF is enabled on all E ports and
TE ports. This default can be disabled by setting the interface as passive.

Clearing FSPF Counters for an Interface

To clear the FSPF statistics counters for an interface, follow this step:
Command
Step 4
switch# clear fspf counters vsan 200 interface fc1/1

FSPF Routes

FSPF routes traffic across the fabric, based on entries in the FSPF database. These routes can be learned
dynamically, or configured statically.
This section includes the following topics:
•
•
•
•
•
OL-16184-01, Cisco MDS SAN-OS Release 3.x
About Fibre Channel Routes, page 25-10
Configuring Fibre Channel Routes, page 25-10
About Broadcast and Multicast Routing, page 25-12
About Multicast Root Switch, page 25-12
Setting the Multicast Root Switch, page 25-12
Purpose
Enters configuration mode.
Configures a specified interface, or if already
configured, enters configuration mode for the
specified interface.
Disables the FSPF protocol for the specified interface
in the specified VSAN.
Reenables the FSPF protocol for the specified
interface in the specified VSAN.
Purpose
Clears the FSPF statistics counters for
the specified interface in VSAN 200.
Cisco MDS 9000 Family CLI Configuration Guide
FSPF Routes
25-9