Chapter 11
Managing Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Default Settings
Table 11-11
Table 11-11
Parameters
Administrative connection
Global switch information
System clock
In-band (VSAN 1) interface
Table 11-12
Table 11-12
Parameters
Initial state when installed
OL-16184-01, Cisco MDS SAN-OS Release 3.x
-- SUCCESS
"Switching over onto standby".
-----------------------------
lists the default settings for the supervisor module.
Default Supervisor Module Settings
lists the default settings for the SSM.
Default SSM Settings
Default
Serial connection.
No value for system name.
•
No value for system contact.
•
No value for location.
•
No value for system clock time.
IP address, subnet mask, and broadcast address assigned to the
VSAN are set to 0.0.0.0.
Default
Power-down state on switches with Cisco MDS SAN-OS
•
Release 2.1(1a) and earlier installed.
Fibre Channel switching mode on switches with Cisco MDS
•
SAN-OS Release 2.1(2) and later installed and SSMs with
EPLD version 2.0(2) and later installed.
Cisco MDS 9000 Family CLI Configuration Guide
Default Settings
11-31