Displaying Ficon-Related Log Information; Default Settings - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 28 Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Example 28-24
case, only a binary configuration is saved until you explicitly issue the copy running start command
again (see
Example 28-24 Displays the Startup Configuration Status
switch# show startup-config
No ASCII config available since configuration was last saved internally
on account of 'active=saved' mode.
Please perform an explicit 'copy running startup` to get ASCII configuration

Displaying FICON-Related Log Information

Example 28-25
Example 28-25 Displays Logging Levels for the FICON Feature
switch# show logging level ficon
Facility
--------
ficon
0(emergencies)
3(errors)
6(information)
Example 28-26 Displays FICON-Related Log File Contents
switch# show logging logfile
...
2004 Feb 25 15:38:50 vegas6 %PORT-5-IF_UP: %$VSAN 75: 2004 Wed Feb 25 13:22:04.
131183%$ Interface fc1/8 is up in mode F
2004 Feb 25 15:38:50 vegas6 %PORT-5-IF_UP: %$VSAN 75: 2004 Wed Feb 25 13:22:04.
131217%$ Interface fc1/9 is up in mode F
...
2004 Feb 25 15:39:09 vegas6 %PORT-5-IF_TRUNK_UP: %$VSAN 75: 2004 Wed Feb 25 13:
22:23.131121%$ Interface fc2/1, vsan 75 is up
2004 Feb 25 15:39:09 vegas6 %PORT-5-IF_TRUNK_UP: %$VSAN 75: 2004 Wed Feb 25 13:
22:23.131121%$ Interface fc2/2, vsan 75 is up
2004 Feb 25 15:39:09 vegas6 %PORT-5-IF_TRUNK_UP: %$VSAN 75: 2004 Wed Feb 25 13:
...
2004 Feb 25 23:22:36 vegas6 %PORT-5-IF_UP: %$VSAN 75: 2004 Wed Feb 25 21:05:42.
99916%$ Interface fc3/6 is up in mode F
2004 Feb 25 23:22:37 vegas6 %PORT-5-IF_UP: %$VSAN 75: 2004 Wed Feb 25 21:05:43.
...

Default Settings

Table 28-3
OL-16184-01, Cisco MDS SAN-OS Release 3.x
displays the switch response to an implicitly-issued copy running start command. In this
Table 28-2)
and Example 28-26 display the logging information for FICON-related configurations.
Default Severity
----------------
2
1(alerts)
4(warnings)
7(debugging)
lists the default settings for FICON features.
Current Session Severity
------------------------
2
2(critical)
5(notifications)
Cisco MDS 9000 Family CLI Configuration Guide
Default Settings
28-49