Default Settings - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 15 Configuring Trunking
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Example 15-2 Displays the Trunking Protocol
switch# show trunk protocol
Trunk protocol is enabled
Example 15-3 Displays Per VSAN Information on Trunk Ports
switch# show interface trunk vsan 1-1000
fc3/1 is not trunking
...
fc3/7 is trunking
...
fc3/10 is trunking
fc3/11 is trunking
...
port-channel 6 is trunking

Default Settings

Table 15-2
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Hardware is Fibre Channel
Port WWN is 20:0d:00:05:30:00:58:1e
Peer port WWN is 20:0d:00:05:30:00:59:1e
Admin port mode is auto, trunk mode is on
Port mode is TE
Port vsan is 1
Speed is 2 Gbps
Receive B2B Credit is 255
Beacon is turned off
Trunk vsans (admin allowed and active) (1)
Trunk vsans (up)
Trunk vsans (isolated)
Trunk vsans (initializing)
5 minutes input rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
5 minutes output rate 0 bits/sec, 0 bytes/sec, 0 frames/sec
233996 frames input, 14154208 bytes, 0 discards
0 CRC, 0 unknown class
0 too long, 0 too short
236 frames output, 13818044 bytes, 0 discards
11 input OLS, 12 LRR, 10 NOS, 28 loop inits
34 output OLS, 19 LRR, 17 NOS, 12 loop inits
Vsan 1000 is down (Isolation due to vsan not configured on peer)
Vsan 1 is up, FCID is 0x760001
Vsan 2 is up, FCID is 0x6f0001
Belongs to port-channel 6
Vsan 1 is up, FCID is 0xef0000
Vsan 2 is up, FCID is 0xef0000
Vsan 1 is up, FCID is 0xef0000
Vsan 2 is up, FCID is 0xef0000
lists the default settings for trunking parameters.
(1)
()
()
Cisco MDS 9000 Family CLI Configuration Guide
Default Settings
15-7