Upgrade Status Verification
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Upgrade Status Verification
Use the show install all status command to view the ongoing install all command or the log of the last
installed install all command from a console, SSH, or Telnet session.
This command presents the install all output on both the active and standby supervisor module even if
you are not connected to the console terminal. It only displays the status of an install all command that
is issued from the CLI (not the GUI). See
Example 7-10 Displays the install all Command Output
switch# show install all status
There is an on-going installation... <---------------------- in progress installation
Enter Ctrl-C to go back to the prompt.
Verifying image bootflash:/b-1.3.0.104
-- SUCCESS
Verifying image bootflash:/i-1.3.0.104
-- SUCCESS
Extracting "system" version from image bootflash:/i-1.3.0.104.
-- SUCCESS
Extracting "kickstart" version from image bootflash:/b-1.3.0.104.
-- SUCCESS
Extracting "loader" version from image bootflash:/b-1.3.0.104.
-- SUCCESS
switch# show install all status
This is the log of last installation.
Verifying image bootflash:/b-1.3.0.104
-- SUCCESS
Verifying image bootflash:/i-1.3.0.104
-- SUCCESS
Extracting "system" version from image bootflash:/i-1.3.0.104.
-- SUCCESS
Extracting "kickstart" version from image bootflash:/b-1.3.0.104.
-- SUCCESS
Extracting "loader" version from image bootflash:/b-1.3.0.104.
-- SUCCESS
Non-Disruptive Upgrades on Fabric and Modular Switches
This section describes how to perform non-disruptive upgrades on the following Cisco Fabric Switches:
•
•
•
•
Cisco MDS 9000 Family CLI Configuration Guide
7-20
Cisco MDS 9124 Multilayer Fabric Switch
Cisco MDS 9134 Multilayer Fabric Switch
Cisco MDS 9222i Multiservice Modular Switch
Cisco Fabric Switch for HP c-Class BladeSystem
Example
7-10.
<<<<<< log of last install
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 7
Software Images