Configuring Individual Afids; Verifying The Afid Database Configuration; About Ivr Without Ivr Nat Or Auto Topology - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 22 Configuring Inter-VSAN Routing
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Configuring Individual AFIDs

To configure individual AFIDs, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# autonomous-fabric-id database
Step 3
switch(config-afid-db)# switch-wwn
20:00:00:0c:91:90:3e:80 autonomous-fabric-id
10 vsan-ranges 1,2,5-8
switch(config-afid-db)# no switch-wwn
20:00:00:0c:91:90:3e:80 autonomous-fabric-id
10 vsan-ranges 2

Verifying the AFID Database Configuration

View the contents of the AFID database using the show autonomous-fabric-id database command.
switch# show autonomous-fabric-id database
SWITCH WWN
--------------------------------------------------------------
20:00:00:0c:91:90:3e:80
Total:
SWITCH WWN
--------------------------------------------------------------
20:00:00:0c:91:90:3e:80
Total:

About IVR Without IVR NAT or Auto Topology

Before configuring an IVR SAN fabric without IVR in NAT mode or IVR topology in auto mode,
consider the following guidelines:
•
•
•
If you change any FSPF link cost, ensure that the FSPF path distance (that is, the sum of the link costs
Tip
on the path) of any IVR path is less than 30,000.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
1 entry in default AFID table
1 entry in AFID table
Configure unique domain IDs across all VSANs and switches participating in IVR operations if you
are not using IVR NAT. The following switches participate in IVR operations:
All edge switches in the edge VSANs (source and destination)
–
All switches in transit VSANs
–
Configure IVR only in the relevant border switches.
Acquire a mandatory Enterprise License Package or SAN-EXTENSION license package and one
active IPS card for this feature.
Purpose
Enters configuration mode.
Enters AFID database configuration submode.
Configures an AFID and VSAN range for a
switch. The valid range for AFIDs is 1 to 64.
Deletes VSAN 2 from AFID 10.
Default-AFID
5
AFID VSANS
10 1,2,5-8
Cisco MDS 9000 Family CLI Configuration Guide
Configuring IVR
22-17