Removing An Assigned Job; Deleting A Schedule Time; Verifying The Command Scheduler Execution Status; Execution Logs - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 18 Scheduling Maintenance Jobs
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Removing an Assigned Job

To remove an assigned job, follow these steps:
Command
Step 1
switch# conf t
switch(config)#
Step 2
switch(config)# scheduler schedule name
weekendbackupqos
switch(config-schedule)#
Step 3
switch(config-schedule)# no job name addMem99

Deleting a Schedule Time

To delete the schedule time, follow these steps:
Command
Step 1
switch# conf t
switch(config)#
Step 2
switch(config)# scheduler schedule
name weekendbackupqos
switch(config-schedule)#
Step 3
switch(config-schedule)# no time

Verifying the Command Scheduler Execution Status

To verify the command scheduler execution status, use the show scheduler schedule command.
switch# show scheduler schedule configureVsan99
Schedule Name
------------------------------------
User Name
Schedule Type
Last Execution Time: Tue Aug 10 09:48:00 2004
-----------------------------------------------
-----------------------------------------------
addMemVsan99

Execution Logs

This section describes execution logs for the command scheduler and contains the following sections:
•
•
•
OL-16184-01, Cisco MDS SAN-OS Release 3.x
: configureVsan99
: admin
: Run once on Tue Aug 10 09:48:00 2004
Job Name
About Execution Logs, page 18-10
Configuring Execution Logs, page 18-10
Clearing the Execution Log File Contents, page 18-10
Purpose
Enters the configuration mode.
Specifies a job schedule (weekendbackupqos)
and enters the submode for that schedule.
Removes a job (addMem99) assigned to this
schedule.
Purpose
Enters the configuration mode.
Defines a job schedule (weekendbackup) and enters the
submode for that schedule.
Deletes the schedule time configuration.The schedule
will not be run until the time is configured again.
Status
Success (0)
Cisco MDS 9000 Family CLI Configuration Guide
Execution Logs
18-9