Verifying The Modem Connection Configuration - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 5 Initial Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Connect the modem to the switch as specified in the Cisco MDS 9500 Series Hardware Guide or the
Step 2
Cisco MDS 9200 Series Hardware Installation Guide.
Step 3 Initialize the modem using the modem connect line command in EXEC mode.

Verifying the Modem Connection Configuration

Use the show line command to verify the configured modem settings.
The following example displays output from an MDS switch with a Supervisor-1 module.
switch# show line
line Console:
line Aux:
The following example displays output from an MDS switch with a Supervisor-2 module.
switch# show line
line Console:
line Aux:
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Enable
Modem Init-String -
default : ATE0Q1&D2&C1S0=1\015
Statistics: tx:12842
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Enable
Modem Init-String -
default : ATE0Q1&D2&C1S0=1\015
Statistics: tx:17
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Enable
Modem Init-String -
default : ATE0Q0V1&D0&C0S0=1
Statistics: tx:12842
Speed: 9600 bauds
Databits: 8 bits per byte
Stopbits: 1 bit(s)
Parity: none
Modem In: Enable
Modem Init-String -
default : ATE0Q0V1&D0&C0S0=1
Statistics: tx:17
rx:366 Register Bits:RTS|CTS|DTR|DSR|CD|RI
rx:0 Register Bits:RTS|DTR
rx:366 Register Bits:RTS|CTS|DTR|DSR|CD|RI
rx:0 Register Bits:RTS|DTR
Cisco MDS 9000 Family CLI Configuration Guide
Configuring Modem Connections
5-35