Configuring Default Zone Qos Priority Attributes - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 23 Configuring and Managing Zones
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 3
switch(config-zone)# attribute qos priority
high
switch(config-zone)# attribute qos priority
medium
switch(config-zone)# attribute qos priority low
switch(config-zone)# no attribute qos priority
high
Step 4
switch(config-zone)# exit
switch(config)#
Step 5
switch(config)# zoneset name QosZoneset vsan 2
switch(config-zoneset)#
Step 6
switch(config-zoneset)# member QosZone
Step 7
switch(config-zoneset)# exit
switch(config)#
Step 8
switch(config)# zoneset activate name
QosZoneset vsan 2

Configuring Default Zone QoS Priority Attributes

QoS priority attribute configuration changes take effect when you activate the zone set of the associated
zone.
If a member is part of two zones with two different QoS priority attributes, the higher QoS value is
Note
implemented. This situation does not arise in the VSAN-based QoS as the first matching entry is
implemented.
To configure the QoS priority attributes for a default zone, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# zone default-zone vsan 1
switch(config-default-zone)#
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Purpose
Configures this zone to assign high priority
QoS traffic to each frame matching this zone.
Configures this zone to assign medium
priority QoS traffic to each frame matching
this zone.
Configures this zone to assign low priority
QoS traffic to each frame matching this zone.
Reverts to using the default low priority for
this zone.
Returns to configuration mode.
Configures a zone set called QosZoneset for
the specified VSAN (vsan 2) and enters zone
set configuration submode.
To activate a zone set, you must first
Tip
create the zone and a zone set.
Adds QosZone as a member of the specified
zone set (QosZoneset).
If the specified zone name was not
Tip
previously configured, this command
will return the
error message.
Returns to configuration mode.
Activates the specified zone set.
Purpose
Enters configuration mode.
Enters the default zone configuration submode.
Cisco MDS 9000 Family CLI Configuration Guide
Advanced Zone Attributes
Zone not present
23-19