Configuring An Allowed-Active List Of Vsans; Displaying Trunking Information - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Displaying Trunking Information

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 15-5
Switch 1
VSAN1
VSAN2
VSAN3
VSAN4
VSAN5

Configuring an Allowed-Active List of VSANs

To configure an allowed-active list of VSANs for an interface, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# interface fc1/1
switch(config-if)#
Step 3
switch(config-if)# switchport trunk allowed vsan 2-4
switch(config-if)# switchport trunk allowed vsan add 5
updated trunking membership
switch(config-if)# no switchport trunk allowed vsan 2-4
switch(config-if)# no switchport trunk allowed vsan add 5
Displaying Trunking Information
The show interface command is invoked from the EXEC mode and displays trunking configurations for
a TE port. Without any arguments, this command displays the information for all of the configured
interfaces in the switch. See Examples
Example 15-1 Displays a Trunked Fibre Channel Interface
switch# show interface fc1/13
fc1/13 is trunking
Cisco MDS 9000 Family CLI Configuration Guide
15-6
Operational and Allowed VSAN Configuration
15-1
Switch 2
VSAN1
VSAN2
VSAN3
Switch 3
VSAN1
VSAN2
VSAN4
VSAN5
Purpose
Enters configuration mode.
Configures the specified interface.
Changes the allowed list for the
specified VSANs.
Expands the specified VSAN (5) to
the new allowed list.
Deletes VSANs 2, 3, and 4.
Deletes the expanded allowed list.
to 15-3.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 15 Configuring Trunking