HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 242

Manual Upgrade on a Dual Supervisor Module Switch
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Before issuing this command, be sure to read the release notes to verify compatibility issues between the
Caution
loader and the kickstart or system images.
To upgrade the loader on either the active or standby supervisor module, follow these steps.
Use the show version command to verify the version on the active and standby supervisor modules.
Step 1
switch# show version
Cisco Storage Area Networking Operating System (SAN-OS) Software
TAC support: http://www.cisco.com/tac
Copyright (c) 2002-2003, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained herein are owned by
Cisco Systems, Inc. and/or other third parties and are used and
distributed under license. Some parts of this software are covered
under the GNU Public License. A copy of the license is available
at http://www.gnu.org/licenses/gpl.html.
Software
BIOS:
loader:
kickstart: version 2.0(1)
system:
BIOS compile time:
kickstart image file is: bootflash:///m9500-sf1ek9-kickstart-mzg.2.0.0.6.bin
kickstart compile time:
system image file is:
system compile time:
Hardware
RAM 1024584 kB
bootflash: 1000944 blocks (block size 512b)
slot0:
172.22.92.181 uptime is 0 days 2 hours 18 minute(s) 1 second(s)
Last reset at 970069 usecs after Tue Sep 16 22:31:25 1980
Reason: Reset Requested by CLI command reload
System version: 2.0(0.6)
Service:
Issue the install module command for the required supervisor module (active or standby). This example
Step 2
displays the command being issued for the standby supervisor module in slot 6.
switch# install module 6 loader bootflash:kickstart-image
Note
Step 3 Use the show version command to verify the updated image on the supervisor module.
switch# show version
Cisco Storage Area Networking Operating System (SAN-OS) Software
TAC support: http://www.cisco.com/tac
Cisco MDS 9000 Family CLI Configuration Guide
7-28
version 1.0.8
version 1.1(2) <-------------------------current running version
version 2.0(1)
08/07/03
10/25/2010 12:00:00
bootflash:///m9500-sf1ek9-mzg.2.0.0.6.bin
10/25/2020 12:00:00
0 blocks (block size 512b)
If you install a loader version that is the same as the currently installed version, the command
will not execute. When both the current version and the installed version are the same, use the
init system command to force a loader upgrade.
Chapter 7 Software Images
OL-16184-01, Cisco MDS SAN-OS Release 3.x