HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 305

Chapter 11 Managing Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 11-7
24-port, and 48-port Generation 2 switching modules.
Table 11-7
LED
Status Green
Speed On
Link
The LEDs on the supervisor module indicate the status of the supervisor module, power supplies, and
the fan module.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
describes the LEDs for the 16-port and 32-port switching modules, and the 4-port, 12-port,
LEDs for the Cisco MDS 9000 Family Fibre Channel Switching Modules
Status Description
All diagnostics pass. The module is operational (normal initialization sequence).
Orange The module is booting or running diagnostics (normal initialization sequence).
or
The inlet air temperature of the system has exceeded the maximum system
operating temperature limit (a minor environmental warning). To ensure
maximum product life, you should immediately correct the environmental
temperature and restore the system to normal operation.
Red The diagnostic test failed. The module is not operational because a fault occurred
during the initialization sequence.
or
he inlet air temperature of the system has exceeded the safe operating
T
temperature limits of the card (a major environmental warning). The card has
been shut down to prevent permanent damage.
2-Gbps mode.
Off 1-Gbps mode.
Solid green Link is up.
Steady Link is up (beacon used to identify port).
flashing
green
Intermittent Link is up (traffic on port).
flashing
green
Solid Link is disabled by software.
yellow
Flashing A fault condition exists.
yellow
Off No link.
Table 11-8 provides more information about these LEDs.
Cisco MDS 9000 Family CLI Configuration Guide
Identifying Module LEDs
11-11