HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 250

Maintaining Supervisor Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
INIT: version 2.78 booting
Checking all filesystems...... done.
WARNING: image sync is going to be disabled after a mgmt0 BIOS netboot
Loading system software
No system image is specified
INIT: Sending processes the TERM signal
Stopping kernel log daemon: klogd.
Sending all processes the TERM signal... done.
Sending all processes the KILL signal... done.
Entering single-user mode...
INIT: Going single user
INIT: Sending processes the TERM signal
Cisco Storage Area Networking Operating System (SAN-OS) Software
TAC support: http://www.cisco.com/tac
Copyright (c) 2002-2006, Cisco Systems, Inc. All rights reserved.
The copyrights to certain works contained herein are owned by
other third parties and are used and distributed under license.
Some parts of this software are covered under the GNU Public
License. A copy of the license is available at
http://www.gnu.org/licenses/gpl.html.
switch(boot)#
The
Enable the management interface (mgmt0).
e.
switch(boot)# config terminal
Enter configuration commands, one per line.
switch(boot)(config)# interface mgmt 0
switch(boot)(config-if)# no shutdown
switch(boot)(config-if)# end
switch(boot)#
Download a Cisco SAN-OS system image to the Supervisor-2 module from a TFTP server.
f.
switch(boot)# copy tftp://10.16.10.100/system-img bootflash:system-img
Trying to connect to tftp server......
Note
Download a kickstart image to the Supervisor-2 module from a TFTP server, if necessary.
g.
switch(boot)# copy tftp://10.16.10.100/kickstart-img bootflash:kickstart-img
Trying to connect to tftp server......
Load the system image on the standby Supervisor-2 module.
h.
switch(boot)# load bootflash:system-img
Load the system image on the standby Supervisor-2 module.
i.
switch(boot)# load bootflash:system-img
Verify that the standby Supervisor-2 module is in the warm standby state by using a show system
Step 11
redundancy status command on the active Supervisor-1 module session.
switch# show system redundancy status
Redundancy mode
---------------
Cisco MDS 9000 Family CLI Configuration Guide
7-36
prompt indicates that you have a usable kickstart image.
switch(boot)#
Ensure that you download the correct Cisco SAN-OS system image. The system image for
Supervisor-2 modules is different from the system image for Supervisor-1 modules.
administrative: HA
operational: Warm
Chapter 7
End with CNTL/Z.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Software Images