Verifying Scheduler Configuration; Deleting A Schedule - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Configuring the Command Scheduler
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 3
switch(config-schedule)# job name addMemVsan99
Step 4
switch(config-schedule)# time start 2004:12:14:23:00
switch(config-schedule)# no time

Verifying Scheduler Configuration

To display the scheduler configuration, use the show scheduler config command.
switch# show scheduler config
config terminal
scheduler enable
scheduler logfile size 512
end
config terminal
scheduler job name addMemVsan99
end
config terminal
scheduler schedule name configureVsan99
end

Deleting a Schedule

To delete a schedule, follow these steps:
Command
Step 1
switch# conf t
switch(config)#
Step 2
switch(config)# no scheduler schedule name
weekendbackup
Cisco MDS 9000 Family CLI Configuration Guide
18-8
config terminal
vsan database
vsan 99 interface fc1/1
vsan 99 interface fc1/2
vsan 99 interface fc1/3
vsan 99 interface fc1/4
time start 2004:8:10:9:52
job name addMemVsan99
Chapter 18 Scheduling Maintenance Jobs
Purpose
Assigns a predefined job name
(addMemVsan99) for this schedule.
Specifies a one-time execution on
December 14, 2004, at 11 p.m.
Deletes the time assigned for this
schedule.
Purpose
Enters the configuration mode.
Deletes the defined schedule.
OL-16184-01, Cisco MDS SAN-OS Release 3.x