HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 165

Chapter 5 Initial Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Enter the number of key bits within the specified range.
Step 15
Enter the number of key bits? (768 to 2048): 768
Enter yes (no is the default) to configure the NTP server.
Step 16
Configure NTP server? (yes/no) [n]: yes
Enter the NTP server IPv4 address.
a.
NTP server IP address: ntp_server_IP_address
Enter shut (shut is the default) to configure the default switch port interface to the shut (disabled) state.
Step 17
Configure default switchport interface state (shut/noshut) [shut]: shut
Note
Enter on (on is the default) to configure the switch port trunk mode.
Step 18
Configure default switchport trunk mode (on/off/auto) [on]: on
Enter yes (yes is the default) to configure the switchport mode F.
Step 19
Configure default switchport mode F (yes/no) [n]: y
Enter on (off is the default) to configure the PortChannel auto-create state.
Step 20
Configure default port-channel auto-create state (on/off) [off]: on
Enter permit (deny is the default) to deny a default zone policy configuration.
Step 21
Configure default zone policy (permit/deny) [deny]: permit
Permits traffic flow to all members of the default zone.
Note If you are executing the setup script after issuing a write erase command, you explicitly must change
the default zone policy to permit for VSAN 1 after finishing the script using the following commands:
switch# config t
switch(config)# zone default-zone permit vsan 1
Enter yes (no is the default) to enable a full zone set distribution (see the
Step 22
on page
Enable full zoneset distribution (yes/no) [n]: yes
Overrides the switch-wide default for the full zone set distribution feature.
You see the new configuration. Review and edit the configuration that you have just entered.
Enter no (no is the default) if you are satisfied with the configuration.
Step 23
The following configuration will be applied:
username admin password admin_pass role network-admin
username user_name password user_pass role network-admin
snmp-server community snmp_community ro
switchname switch
interface mgmt0
ip address ip_address subnet_mask
no shutdown
ip routing
OL-16184-01, Cisco MDS SAN-OS Release 3.x
The management ethernet interface is not shut down at this point—only the Fibre Channel,
iSCSI, FCIP, and Gigabit Ethernet interfaces are shut down.
23-13).
"Zone Set Distribution" section
Cisco MDS 9000 Family CLI Configuration Guide
Initial Setup Routine
5-9