Advanced Fcip Profile Configuration; Configuring Tcp Listener Ports - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Configuring FCIP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Advanced FCIP Profile Configuration

A basic FCIP configuration uses the local IP address to configure the FCIP profile. In addition to the
local IP address and the local port, you can specify other TCP parameters as part of the FCIP profile
configuration.
•
•
•
FCIP configuration options can be accessed from the

Configuring TCP Listener Ports

To configure TCP listener ports, follow these steps:
Command
Step 1
switch# config terminal
switch(config)#
Step 2
switch(config)# fcip profile 20
switch(config-profile)#
The default TCP port for FCIP is 3225. You can change this port using the port command.
To change the default FCIP port number (3225), follow these steps:
Command
Step 1
switch(config-profile)# port 5000
switch(config-profile)# no port
Cisco MDS 9000 Family CLI Configuration Guide
40-12
Configuring TCP Listener Ports, page 40-12
Configuring TCP Parameters, page 40-13
Displaying FCIP Profile Configuration Information, page 40-17
switch(config-profile)#
Purpose
Enters configuration mode.
Creates the profile (if it does not already exist) and enters profile
configuration submode. The valid range is from 1 to 255.
Purpose
Associates the profile with the local port number (5000).
Reverts to the default 3225 port.
Chapter 40 Configuring FCIP
submode prompt.
OL-16184-01, Cisco MDS SAN-OS Release 3.x