HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 238

Non-Disruptive Upgrades on Fabric and Modular Switches
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Compatibility check is done:
Module
------
Images will be upgraded according to following table:
Module
------
Do you want to continue with the installation (y/n)?
Install is in progress, please wait.
Notifying services about the upgrade.
[####################] 100% -- SUCCESS
Setting boot variables.
[####################] 100% -- SUCCESS
Performing configuration copy.
[####################] 100% -- SUCCESS
Converting startup config.
[####################] 100% -- SUCCESS
Upgrade can no longer be aborted, any failure will result in a disruptive upgrade.
<---Note that after this point you cannot abort the upgrade.
Freeing memory in the file system.
[####################] 100% -- SUCCESS
Loading images into memory.
[####################] 100% -- SUCCESS
Saving linecard runtime state.
[####################] 100% -- SUCCESS
Saving supervisor runtime state.
[####################] 100% -- SUCCESS
Saving mts state.
[####################] 100% -- SUCCESS
Rebooting the switch to proceed with the upgrade.
Continuing with installation process, please wait.
The login will be disabled until the installation is completed.
Status for linecard upgrade.
[####################] 100% -- SUCCESS
Performing supervisor state verification.
[####################] 100% -- SUCCESS
Install has been successful.
Cisco MDS 9000 Family CLI Configuration Guide
7-24
bootable Impact
-------- --------------
1 yes non-disruptive
Image Running-Version(pri:alt)
---------- --------------------------
1 system 3.1(1)
1 kickstart 3.1(1)
1 bios v1.0.0(10/04/06): v1.0.0(10/04/06) v1.0.0(10/04/06)
Install-type Reason
------------ ------
reset
New-Version
--------------------
3.1(1u)
3.1(1u)
[n]
Chapter 7 Software Images
Upg-Required
------------
yes
yes
no
OL-16184-01, Cisco MDS SAN-OS Release 3.x