Configuring FICON Ports
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
•
•
•
•
•
•
Binding Port Numbers to PortChannels
All port number assignments to PortChannels or FCIP interfaces are lost (cannot be retrieved) when
Caution
FICON is disabled on all VSANs.
You can bind (or associate) a PortChannel with a FICON port number to bring up that interface.
To bind a PortChannel with a FICON port number, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# interface Port-channel 1
switch(config-if)#
Step 3
switch(config-if)# ficon portnumber 234
Binding Port Numbers to FCIP Interfaces
You can bind (or associate) an FCIP interface with a FICON port number to bring up that interface.
To bind an FCIP interface with a FICON port number, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch1(config)# interface fcip 51
switch1(config-if)#
Step 3
switch(config-if)# ficon portnumber 208
Configuring Port Blocking
If you block a port, the port is retained in the operationally down state. If you unblock a port, a port
initialization is attempted. When a port is blocked, data and control traffic are not allowed on that port.
Physical Fibre Channel port blocks will continue to transmit an Off-line state (OLS) primitive sequence
on a blocked port.
Cisco MDS 9000 Family CLI Configuration Guide
28-24
Port Prohibiting, page 28-25
Assigning a Port Address Name, page 28-26
About RLIR, page 28-27
Specifying an RLIR Preferred Host, page 28-27
Displaying RLIR Information, page 28-28
Clearing RLIR Information, page 28-32
Purpose
Enters configuration mode.
Enters the PortChannel interface configuration mode.
Assigns the FICON port number to the selected
PortChannel port.
Purpose
Enters configuration mode.
Creates an FCIP interface (51).
Assigns the FICON port number to the selected FCIP
interface.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Chapter 28
Configuring FICON