HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 163

Chapter 5 Initial Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Enter yes (yes is the default) to create an SNMPv3 account.
Step 6
Configure SNMPv3 Management parameters (yes/no) [y]: yes
Enter the user name (admin is the default).
a.
SNMPv3 user name [admin]: admin
Enter the SNMPv3 password (minimum of eight characters). The default is admin123.
b.
SNMPv3 user authentication password: admin_pass
Note
Enter yes (no is the default) to configure the read-only or read-write SNMP community string.
Step 7
Configure read-only SNMP community string (yes/no) [n]: yes
Enter the SNMP community string.
a.
SNMP community string: snmp_community
Step 8 Enter a name for the switch.
Note
Enter the switch name: switch_name
Enter yes (yes is the default) to configure out-of-band management.
Step 9
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: yes
Enter the mgmt0 IPv4 address.
a.
Mgmt0 IPv4 address: ip_address
Enter the mgmt0 IPv4 subnet mask.
b.
Mgmt0 IPv4 netmask: subnet_mask
Enter yes (yes is the default) to configure the IPv4 default gateway (recommended).
Step 10
Configure the default-gateway: (yes/no) [y]: yes
Enter the default gateway IPv4 address.
a.
IPv4 address of the default-gateway: default_gateway
Enter yes (no is the default) to configure advanced IP options such as in-band management, static routes,
Step 11
default network, DNS, and domain name.
Configure Advanced IP options (yes/no)? [n]: yes
Enter no (no is the default) at the in-band management configuration prompt.
a.
Continue with in-band (VSAN1) management configuration? (yes/no) [no]: no
Enter yes (yes is the default) to enable IPv4 routing capabilities.
b.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
By default, if the admin password is at least eight characters, then the SNMP authentication
password is the same as the admin password (at least eight characters). If the admin password is
less than eight characters, then you need to provide a new password for SNMP. The admin
password can have a minimum of one character, but the SNMP authentication password must
have a minimum of eight characters.
The switch name is limited to 32 alphanumeric characters. The default is switch.
Cisco MDS 9000 Family CLI Configuration Guide
Initial Setup Routine
5-7