HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 247

Chapter 7 Software Images
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
To migrate from Supervisor-1 modules to Supervisor-2 modules on a Cisco MDS 9509 or 9506 switch,
follow these steps:
Ensure that the configured domain ID is the same as the current domain ID for every VSAN on the switch
Step 1
by following these steps:
Issue a show vsan command to display all the VSANs on the switch.
a.
switch# show vsan
vsan 1 information
vsan 2 information
vsan 10 information
vsan 4094:isolated_vsan
Display the current and configured domain IDs for a VSAN.
b.
switch# show fcdomain vsan 1
The local switch is the Principal Switch.
Local switch run time information:
Local switch configuration information:
Principal switch run time information:
Change the configured domain ID if it differs from the current domain ID.
c.
switch# config t
switch(config)# fcdomain domain 106 static vsan 1
switch(config)# exit
switch#
Repeat
d.
Save the configuration.
Step 2
OL-16184-01, Cisco MDS SAN-OS Release 3.x
name:VSAN0001 state:active
interoperability mode:default
loadbalancing:src-id/dst-id/oxid
operational state:down
name:VSAN0002 state:active
interoperability mode:default
loadbalancing:src-id/dst-id/oxid
operational state:down
name:VSAN0010 state:active
interoperability mode:default
loadbalancing:src-id/dst-id
operational state:down
State: Stable
Local switch WWN: 20:01:00:05:30:00:35:df
Running fabric name: 20:01:00:05:30:00:35:df
Running priority: 128
Current domain ID: 0x6a(106)
State: Enabled
FCID persistence: Enabled
Auto-reconfiguration: Disabled
Contiguous-allocation: Disabled
Configured fabric name: 20:01:00:05:30:00:28:df
Configured priority: 128
Configured domain ID: 0x00(0) (preferred)
Running priority: 128
Step b and Step c for each VSAN on the switch.
Maintaining Supervisor Modules
Cisco MDS 9000 Family CLI Configuration Guide
7-33