HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 749

Chapter 31 Configuring SNMP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Table 31-1
MIB
CISCO-FDMI-MIB
CISCO-FSPF-MIB
CISCO-LICENSE-MGR-MIB
IF-MIB
CISCO-PSM-MIB
CISCO-RSCN-MIB
SNMPv2-MIB
VRRP-MIB, CISCO-IETF-VRRP-MIB
CISCO-ZS-MIB
The following notifications are enabled by default:
entity fru
•
license
•
link ietf-extended
•
All other notifications are disabled by default.
To enable individual notifications, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# snmp-server enable traps
fcdomain
switch(config)# no snmp-server enable
traps
You can use the show snmp trap command to display all the notifications and their status.
switch# show snmp trap
Trap type
---------
entity fru
fcc
fcdomain
fcns
fcs request-reject
fcs discovery-complete
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Enabling SNMP Notifications (continued)
Related Commands
snmp-server enable traps fdmi
snmp-server enable traps fspf
snmp-server enable traps license
snmp-server enable traps link
snmp-server enable traps port-security
snmp-server enable traps rscn
snmp-server enable traps rscn els
snmp-server enable traps rscn ils
snmp-server enable traps snmp
snmp-server enable traps snmp authentication
snmp-server enable traps vrrp
snmp-server enable traps zone
snmp-server enable traps zone
default-zone-behavior-change
snmp-server enable traps zone merge-failure
snmp-server enable traps zone merge-success
snmp-server enable traps zone request-reject
snmp-server enable traps zone unsupp-mem
Purpose
Enters configuration mode.
Enables the specified SNMP (fcdomain) notification.
Disables the specified SNMP notification. If a
notification name is not specified, all notifications are
disabled.
Enabled
-------
Yes
No
No
No
No
No
Cisco MDS 9000 Family CLI Configuration Guide
SNMP Trap and Inform Notifications
31-11