Using The Install Ssi Command - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 11 Managing Modules
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
The reload command power cycles the SSM.
Caution
Step 8 Issue the show module command to verify the status of the SSM.
switch# show module
Mod
---
4
5
6
Mod
---
4
5
6
Mod
-------- -----------------------------
4
Mod
---
4
5
6
* this terminal session

Using the install ssi Command

You can use the install ssi command to update the boot image on an SSM. If the SSM is performing Fibre
Channel switching and no Intelligent Storage Services are provisioned on the module, this operation
does not disrupt traffic through the module. If the SSM is configured for Intelligent Storage Services, a
warning is displayed at the command prompt indicating that the operation will disrupt traffic and asking
if you wish to continue.
The SSM must be running EPLD version 2.1(2) to use the install ssi command. You must install the SSM
Note
on a Cisco MDS 9500 Series switch to update the EPLD. See the
page
To upgrade or downgrade the SSM boot image for Intelligent Storage Services, follow these steps:
Log into the switch through the console port, an SSH session, or a Telnet session.
Step 1
Verify that the SSM is physically installed in the switch. If the module is not physically installed, insert
Step 2
it into the desired slot. Issue a show module command to verify the status of the module.
switch# show module
Mod
---
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Reloading the SSM disrupts traffic through the module.
Ports Module-Type
----- -------------------------------- ------------------ ------------
32 Storage Services Module
0 Supervisor/Fabric-1
0 Supervisor/Fabric-1
Sw Hw World-Wide-Name(s) (WWN)
----------- ------ --------------------------------------------------
2.1(2) 0.30 20:c1:00:05:30:00:06:de to 20:e0:00:05:30:00:06:de
2.1(2) 4.0 --
2.1(2) 4.0 --
Application Image Description
SSI linecard image
MAC-Address(es)
--------------------------------------
00-05-30-00-9e-b2 to 00-05-30-00-9e-b6
00-0e-38-c6-2c-6c to 00-0e-38-c6-2c-70
00-0f-34-94-4d-34 to 00-0f-34-94-4d-38
11-12.
Ports Module-Type
----- -------------------------------- ------------------ ------------
Upgrading the SSI Boot Image on an SSM
Model Status
DS-X9032-SSM ok
DS-X9530-SF1-K9 active *
DS-X9530-SF1-K9 ha-standby
Application Image Version
-------------------------
2.1(1a)
Serial-Num
----------
JAB06480590
JAB082504MQ
JAB083407D3
"EPLD Configuration" section on
Model Status
Cisco MDS 9000 Family CLI Configuration Guide
11-25