About Luns In Ivr Zoning; Configuring Luns In Ivr Zoning - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

IVR Zones and IVR Zone Sets
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Example 22-14 Displays Status Information for the IVR Zone Set
switch# show ivr zoneset status
Zoneset Status
_______________
status per vsan:
__________________
Repeat this configuration in all border switches participating in the IVR configuration.
Tip
Using the Cisco MDS Fabric Manager, you can distribute IVR zone configurations to all IVR-capable
Note
switches in the interconnected VSAN network. Refer to the Cisco MDS 9000 Family Fabric Manager
Configuration Guide.

About LUNs in IVR Zoning

LUN zoning can be used between members of active IVR zones.You can configure the service by
creating and activating LUN zones between the desired IVR zone members in all relevant edge VSANs
using the zoning interface or you can use LUN zoning directly supported by IVR. For more details on
the advantages of LUN zoning, see the

Configuring LUNs in IVR Zoning

To configure LUNs in IVR zoning, follow these steps:
Command
Step 1
switch# config t
switch(config)#
Step 2
switch(config)# ivr zone name IvrLunZone
switch(config-ivr-zone)#
Cisco MDS 9000 Family CLI Configuration Guide
22-34
name : IVR_ZoneSet1
state : activation success
last activate time : Sat Mar 22 21:38:46 1980
force option : off
vsan status
____ ______
1 active
2 active
"About LUN Zoning" section on page
Purpose
Enters configuration mode.
Configures an IVR zone called IvrLunZone.
Chapter 22 Configuring Inter-VSAN Routing
23-21.
OL-16184-01, Cisco MDS SAN-OS Release 3.x