HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 1083

Chapter 42 Configuring iSCSI
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
switch(config-iscsi-init)# static pWWN system-assign 1
switch(config-iscsi-init)# static nWWN system-assign
switch(config)# iscsi initiator ip address 10.15.1.11
switch(config-iscsi-init)# static pwwn system-assigned 1
switch(config-iscsi-init)# vsan 2
Note
View the configured WWNs.
Step 8
Note
switch# show iscsi initiator configured
iSCSI Node name is iqn.1987-05.com.cisco:01.e41695d16b1a
Member of vsans: 1
Node WWN is 20:03:00:0b:fd:44:68:c2
No. of PWWN: 1
iSCSI Node name is 10.15.1.11
Member of vsans: 2
No. of PWWN: 1
Create a zone with host 1.
Step 9
switch(config)# zone name iscsi-zone-1 vsan 1
Add three members to the zone named iscsi-zone-1.
Step 10
Note
The following command is based on the symbolic node name.
•
switch(config-zone)# member symbolic-nodename iqn.1987-05.com.cisco:01.e41695d16b1a
The following command is based on the persistent pWWN assigned to the initiator. You can obtain
•
the pWWN from the show iscsi initiator output.
switch(config-zone)# member pwwn 20:02:00:0b:fd:44:68:c2
Create a zone with host 2 and two Fibre Channel targets.
Step 11
Note
switch(config)# zone name iscsi-zone-2 vsan 2
Activate the zone set in VSAN 2
Step 12
switch(config)# zoneset activate name iscsi-zoneset-v2 vsan 2
Zoneset activation initiated. check zone status
switch# show zoneset active vsan 2
zoneset name iscsi-zoneset-v2 vsan 2
zone name iscsi-zone-2 vsan 2
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Host 1 is configured in VSAN 2.
The WWNs are assigned by the system. The initiators are members of different VSANs.
Port WWN is 20:02:00:0b:fd:44:68:c2
Port WWN is 20:06:00:0b:fd:44:68:c2
Fibre Channel storage for zone membership for the iSCSI initiator, either the iSCSI symbolic
node name or the pWWN, can be used. In this case, the pWWN is persistent.
If the host is in VSAN 2, the Fibre Channel targets and zone must also be in VSAN 2.
iSCSI Authentication Setup Guidelines and Scenarios
<-----------------------------------Host 1
Cisco MDS 9000 Family CLI Configuration Guide
42-75