Displaying Tape Acceleration Activity Information - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 40 Configuring FCIP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
Step 3
switch1(config-if)# write-accelerator
tape-accelerator
switch1(config-if)# write-accelerator
tape-accelerator flow-control-buffer-size
auto
switch1(config-if)# write-accelerator
tape-accelerator flow-control-buffer-size
2048
switch1(config-if)# no write-accelerator
tape-accelerator
switch1(config-if)# no write-accelerator
tape-accelerator flow-control-buffer-size
2048
switch1(config-if)# no write-accelerator

Displaying Tape Acceleration Activity Information

Example 40-11
activity.
Example 40-11 Displays Information About Tapes for Which Exchanges are Tape Accelerated
switch# show fcip tape-session summary
-------------------------------------------------------------------------------
Tunnel
-------------------------------------------------------------------------------
1
2
-------------------------------------------------------------------------------
Example 40-12 Displays Information About Tapes for Which Exchanges are Tape Accelerated at the
switch# show fcip tape-session tunnel 1 host-end
HOST TAPE SESSIONS (1 entries TOTAL entries 1)
Host Tape Session #1
FCID 0xEF0001, VSAN 1, LUN 0x0002
Outstanding Exchanges 0, Outstanding Writes 0
Target End Write Buffering 0 Bytes, Auto Max Writes 3
Flags 0x0, FSM state Non TA Mode
Cached Reads 0
First index 0xfffffff7, Last index 0xfffffff7, RA index 0x0000f99a
Current index=0xfffffffe, Els Oxid 0xfff7
Hosts 1
FCID 0x770100
OL-16184-01, Cisco MDS SAN-OS Release 3.x
through Example 40-14
Tunnel End tape-fcid
host-end EF0001
targ-end 650001
Host-End FCIP Link
Purpose
Enables tape acceleration (and write acceleration—if
not already enabled).
Enables tape acceleration with automatic flow
control (default).
Sets tape acceleration flow control buffer size to 2
MB.
Disables tape acceleration (default) and resets the
FCIP tunnel.
Note The write acceleration feature remains
enabled.
Changes the flow control buffer size to the default
value of automatic. The tape acceleration and write
acceleration features remain enabled. This command
does not reset the FCIP tunnel.
Disables both the write acceleration and tape
acceleration features and resets the FCIP tunnel.
show how to display information about tape acceleration
lun vsan num-hosts
0x0002 0001
0x0003 0010
Cisco MDS 9000 Family CLI Configuration Guide
Configuring FCIP
1
2
40-35