HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 229

Chapter 7 Software Images
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Module 2: Disruptive upgrading.
...
-- SUCCESS
Module 3: Disruptive upgrading.
...
-- SUCCESS
Install has been successful.
MDS Switch
Hacienda login:
Example 7-6
that contains an SSI image.The install all command syncs the SSI image to the standby supervisor
module.
You can use the install all command for the SSM only if the SSM is already up and running. For first
Note
time SSM installations, see the
Example 7-6
Cisco-MDS# install all system bootflash:isan-2-1-1a kickstart
bootflash:boot-2-1-1a
Verifying image bootflash:/ssi-2.1.1a
[####################] 100% -- SUCCESS
Verifying image bootflash:/boot-2-1-1a
[####################] 100% -- SUCCESS
Verifying image bootflash:/isan-2-1-1a
[####################] 100% -- SUCCESS
Extracting "slc" version from image bootflash:/isan-2-1-1a.
[####################] 100% -- SUCCESS
Extracting "ips4" version from image bootflash:/isan-2-1-1a.
[####################] 100% -- SUCCESS
Extracting "system" version from image bootflash:/isan-2-1-1a.
[####################] 100% -- SUCCESS
Extracting "kickstart" version from image bootflash:/boot-2-1-1a.
[####################] 100% -- SUCCESS
Extracting "loader" version from image bootflash:/boot-2-1-1a.
[####################] 100% -- SUCCESS
Compatibility check is done:
Module
------
Images will be upgraded according to following table:
OL-16184-01, Cisco MDS SAN-OS Release 3.x
displays the result of the install all command issued from a console terminal for a system
"Upgrading the SSI Boot Image on an SSM" section on page
Successful install all Command Including an SSI Image
ssi bootflash:ssi-2.1.1a
bootable Impact
-------- --------------
2 yes non-disruptive
3 yes disruptive
4 yes disruptive
5 yes non-disruptive
Install-type Reason
------------ ------
rolling
rolling Hitless upgrade is not supported
rolling Hitless upgrade is not supported
reset
Cisco MDS 9000 Family CLI Configuration Guide
Automated Upgrades
11-19.
7-15