HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 244

Manual Upgrade on a Dual Supervisor Module Switch
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Cisco Storage Area Networking Operating System (SAN-OS) Software
TAC support: http://www.cisco.com/tac
Copyright (c) 2002-2003 by Cisco Systems, Inc. All rights reserved.
The copyright for certain works contained herein are owned by
Cisco Systems, Inc. and/or other third parties and are used and
distributed under license.
Software
BIOS:
loader:
kickstart: version 1.0(3)
system:
BIOS compile time:
kickstart image file is: bootflash:/kickstart-image
kickstart compile time:
system image file is:
system compile time:
Hardware
RAM 1027564 kB
Step 2 Verify that the BIOS version of the system image is different from the running image.
switch# show version image bootflash:system-image
image name: m9500-sf1ek9-mz.1.0.3.bin
bios:
system:
compiled:
system service's list
package name
acl
ascii-cfg
bios_daemon
...
Note
Step 3 Run the install module slot# bios command to install each module (if required). In this example, the
supervisor module in slot 6 was updated.
switch# install module 6 bios system bootflash:system-image
Started bios programming .... please wait
[########################################] 100%
BIOS upgrade succeeded for module 1
Caution
Issue the show version command to verify that the module was updated with a the new BIOS version.
Step 4
switch# show version module 6
ModNo
6
Cisco MDS 9000 Family CLI Configuration Guide
7-30
<--------------- current running version
version 1.0(6)
version 1.0(3)
version 1.0(3)
01/27/03
01/25/2003 12:00:00
bootflash:/system-image
01/25/2003 12:00:00
version v1.0.6(01/27/03)
version 1.0(3)
2/28/2003 5:00:00
package version
1.0(3)
1.0(3)
1.0(3)
If the versions are different, issue the install module command as specified in Step 3. If they are
the same, you do not need to update the BIOS image.
Do not reboot the switch if any errors were indicated in response to this command.
Image Type SW Version
Stby Sup 1.3(2)
<--------------- BIOS is same version 1.0.6
SW Interim Version BIOS Version
1.3(1.1) 1.1.0 [last 1.0.6]
Chapter 7 Software Images
OL-16184-01, Cisco MDS SAN-OS Release 3.x