Deleting Static Vsans; About Load Balancing - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

VSAN Configuration
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Figure 19-4
Default
VSAN
fc1/1
fc1/2
Isolated
VSAN
•
•
The allowed VSAN list is not affected when a VSAN is deleted (see
Note
Trunking").
Any commands for a nonconfigured VSAN are rejected. For example, if VSAN 10 is not configured in
the system, then a command request to move a port to VSAN 10 is rejected.

Deleting Static VSANs

To delete a VSAN and its various attributes, follow these steps:
Command
Step 1
switch# config t
Step 2
switch(config)# vsan database
switch(config-db)#
Step 3
switch-config-db# vsan 2
switch(config-vsan-db)#
Step 4
switch(config-vsan-db)# no vsan 5
switch(config-vsan-db)#
Step 5
switch(config-vsan-db)# end
switch#

About Load Balancing

Load balancing attributes indicate the use of the source-destination ID (src-dst-id) or the originator
exchange OX ID (src-dst-ox-id, the default) for load balancing path selection.
Cisco MDS 9000 Family CLI Configuration Guide
19-10
VSAN Port Membership Details
Before
VSAN 7
fc1/3
fc1/4
VSAN 12
fc1/5
fc1/6
Switch 1
VSAN-based runtime (name server), zoning, and configuration (static routes) information is
removed when the VSAN is deleted.
Configured VSAN interface information is removed when the VSAN is deleted.
Chapter 19
After
Default VSAN 7
VSAN
fc1/1 fc1/3
fc1/2 fc1/4
Isolated VSAN 12
VSAN
fc1/5 fc1/5
fc1/6 fc1/6
Switch 1
Purpose
Enters configuration mode.
Configures the VSAN database.
Places you in VSAN configuration mode.
Deletes VSAN 5 from the database and switch.
Places you in EXEC mode.
OL-16184-01, Cisco MDS SAN-OS Release 3.x
Configuring and Managing VSANs
Chapter 15, "Configuring