Default Settings - HP Cisco MDS 9020 - Fabric Switch Configuration Manual

Chapter 40 Configuring FCIP
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

Default Settings

Table 40-4
Table 40-6
Parameters
TCP default port for FCIP
minimum-retransmit-time
Keepalive timeout
Maximum retransmissions
PMTU discovery
pmtu-enable reset-timeout
SACK
max-bandwidth
min-available-bandwidth
round-trip-time
Buffer size
Control TCP and data connection
TCP congestion window monitoring
Burst size
TCP connection mode
special-frame
FCIP timestamp
acceptable-diff range to accept packets
B port keepalive responses
Write acceleration
Tape acceleration
OL-16184-01, Cisco MDS SAN-OS Release 3.x
0 comp expanded
lists the default settings for FCIP parameters.
Default FCIP Parameters
Default
3225
200 msec
60 sec
4 retransmissions
Enabled
3600 sec
Enabled
1Gbps
500 Mbps
1 msec
0 KB
No packets are transmitted
Enabled
50 KB
Active mode is enabled
Disabled
Disabled
+/– 2000 msec
Disabled
Disabled
Disabled
Cisco MDS 9000 Family CLI Configuration Guide
Default Settings
40-39