HP Cisco MDS 9020 - Fabric Switch Configuration Manual page 679

Chapter 28 Configuring FICON
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Enable active=saved? (yes/no) [yes]: yes
Enter yes (the default is yes) if you wish to configure additional FICON VSANs.
Step 11
Would you like to configure additional ficon vsans (yes/no) [yes]: yes
Review and edit the configuration that you have just entered.
Step 12
Enter no (the default is no) if you are satisfied with the configuration.
Step 13
Note
The following configuration will be applied:
fcdomain domain 2 static vsan 1
fcdomain restart disruptive vsan 1
fabric-binding database vsan 1
swwn 11:00:02:01:aa:bb:cc:00 domain 4
fabric-binding activate vsan 1
zone default-zone permit vsan 1
ficon vsan 1
no host port control
fcdomain domain 3 static vsan 2
fcdomain restart disruptive vsan 2
fabric-binding activate vsan 2 force
zone default-zone permit vsan 2
ficon vsan 2
no host port control
no active equals saved
vsan database
vsan 3
fcdomain domain 5 static vsan 3
fcdomain restart disruptive vsan 3
fabric-binding activate vsan 3 force
zone default-zone permit vsan 3
ficon vsan 3
no snmp port control
no active equals saved
Would you like to edit the configuration? (yes/no) [no]: no
Enter yes (the default is yes) to use and save this configuration. The implemented commands are
Step 14
displayed. After FICON is enabled for the specified VSAN, you are returned to the EXEC mode switch
prompt.
Use this configuration and apply it? (yes/no) [yes]: yes
`fcdomain domain 2 static vsan 1`
`fcdomain restart disruptive vsan 1`
`fabric-binding database vsan 1`
`swwn 11:00:02:01:aa:bb:cc:00 domain 4`
`fabric-binding activate vsan 1`
`zone default-zone permit vsan 1`
`ficon vsan 1`
`no host port control`
`fcdomain domain 3 static vsan 2`
`fcdomain restart disruptive vsan 2`
`fabric-binding activate vsan 2 force`
OL-16184-01, Cisco MDS SAN-OS Release 3.x
For documentation purposes, the following configurations shows three VSANs with different
FICON settings. These settings provide a sample output for different FICON scenarios.
Cisco MDS 9000 Family CLI Configuration Guide
Configuring FICON
28-17