Ricoh Aficio 2045e General Settings Manual page 505

F
Place the next original on the expo-
sure glass within 60 seconds after
the machine has finished scanning
the first original.
Repeat steps D to F for all origi-
G
nals.
H Place the last original, and then
press [#].
-Checking the transmission
settings
You can check the transmission set-
tings (e.g. destination and transmis-
sion mode) on the display.
Press the {Check Modes} key.
A
The following display appears.
Note
r Press
to switch the destina-
tion between fax number and e-
mail address.
B
After checking the settings on the
display, press the {Check Modes}
key.
The display before the {Check
Modes} key was pressed appears.
-Broadcasting Sequence
If you dial several destinations for the
same message (broadcasting), the
messages are sent in the order in
which they were dialed. If the fax
message could not be transmitted, the
machine redials that destination after
the last destination specified for
broadcasting. For example, if you
specify four destinations, A through
D, for broadcasting, and if the lines to
destinations A and C are busy, the
machine dials the destinations in the
following order: A, B, C, D, A, and C.
See p.79 "Simultaneous Broadcast",
Facsimile Reference <Advanced Fea-
tures>
-Checking the Transmission
Progress
To check which destinations the fax
message has been sent to so far, print
the TX file list. See p.25 "Printing a
List of Files in Memory (Print TX File
List)", Facsimile Reference <Advanced
Features>
Memory Transmission
23
2