The Machine Does Not Print - Ricoh Aficio 2045e General Settings Manual

Troubleshooting

The Machine Does Not Print

Possible Cause
Is the power on?
Is the machine online?
Does the printer function
status indicator stay red?
Is there a warning status or
error message on the dis-
play panel?
4
Can you print a configura-
tion page?
Is the interface cable con-
nected securely to the ma-
chine and computer?
Are you using the correct
interface cable?
Was the interface cable
connected after the ma-
chine was turned on?
Is the signal status satisfac-
tory when using wireless
LAN in infrastructure
mode ?
When using wireless LAN,
is the SSID correctly set?
28
Check the cable is securely plugged into the power outlet and the
machine.
Turn on the main power switch.
If not, press [fOnline] on the display panel.
If so, check the error message on the display panel and take re-
quired action.
If so, check the error message or warning status on the display
panel and take the required action.
If you cannot print a configuration page, there maybe a machine
malfunction. Contact your sales or service representative.
See p.38 "Printing the configuration page" for printing a configu-
ration page.
Connect the interface cable securely. If it has a fastener, fasten that
securely as well.
See "Connecting the Machine", Printer Reference 1.
The type of interface cable you should use depends on the compu-
ter. Be sure to use the correct one. If the cable is damaged or worn,
replace it.
See "Connecting the Machine", Printer Reference 1.
Connect the interface cable before turning on the machine.
To check signal status, press {User Tools/Counter} on the display
panel, and then press [System Settings] on the display panel. On the
[Interface Settings] tab, select [IEEE 802.11b], and then press [Wireless
LAN Signal]. If signal quality is poor, move the machine to a loca-
tion where radio waves can pass or remove objects that might
cause interference.
Note
You can check signal status only when using wireless LAN in
infrastructure mode.
Check using the machine's display panel that the SSID is correctly
set.
See "Interface Settings/IEEE 802.11b (Option)", General Settings
Guide.
Solutions