Ricoh Aficio 2045e General Settings Manual page 297

SLP
Use the "slp" command to configure
SLP settings.
You can search the NetWare server
using SLP in the PureIP environment
of NetWare5/5.1, 6. Use the "slp"
command to configure the value of
TTL used by the SLP multi-cast-pack-
et.
Note
❒ The default value of TTL is "1". A
search is executed only within a lo-
cal segment. If the router does not
support multi-cast, the settings are
not available even if the TTL value
is increased.
❒ The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
SPRINT
Use the "sprint" command to view
and configure SCSI print (SBP-2) on
IEEE 1394.
Limitation
❒ You can use this function when the
optional IEEE 1394 board is in-
stalled.
❖ ❖ ❖ ❖ Viewing settings
The following command displays
the current IEEE 1394 (SCSI print)
settings:
msh> sprint
❖ ❖ ❖ ❖ Bidirectional configuration for IEEE
1394 (SCSI print)
msh> sprint bidi {on |
off}
Use this setting to select whether
IEEE 1394 (SCSI print) is bidirectional
or not. The default is "on".
Remote Maintenance by telnet
Setting IEEE 802.11b
Use the "wiconfig" command to con-
figure IEEE 802.11b settings.
Limitation
❒ You can make settings when in-
stalling the optional 802.11b inter-
face kit.
❖ ❖ ❖ ❖ View settings
The following command displays
the current IEEE 802.11b settings.
msh> wiconfig
The following command displays
the IEEE 802.11b card information.
msh> wiconfig cardinfo
Note
❒ If the IEEE 802.11b interface is
not working correctly, the IEEE
802.11b card information is not
displayed.
❖ ❖ ❖ ❖ Configuration
Parameter
mode
[ap|802.11adhoc|
adhoc]
Value to be
configured
You can set infra-
structure mode
(ap), 802.11 ad hoc
mode
(802.11adhoc), or
ad hoc mode (ad-
hoc).
The default is
802.11 ad hoc
mode.
9
97