Ricoh Aficio 2045e General Settings Manual page 750

Key Operator Setting
Programming Bypass Tray Paper
Size
A Press [Bypass Tray Paper Size].
You can select a size from [Auto
Detect], [Standard Size], or [Cus-
tom Size].
If you select [Auto Detect], pro-
ceed to steps B and G.
If you select [Standard Size], pro-
ceed to steps B, C, and G.
If you select [Custom Size], pro-
ceed to steps B , and D to G.
B Select the size you want to pro-
gram.
Note
r If you select [Auto Detect], the
machine recognizes the pa-
per size automatically.
9
• The machine will detect
the paper size for the by-
pass tray as the short edge
of the paper is inserted
into the machine. Even if
you placed an A4 size
sheet in theK orientation,
the machine will detect it
as A3L.
r If you select [Standard Size],
select a paper size displayed,
and then proceed to step G.
r If you select [Custom Size],
proceed to step D.
C Select the size you want to pro-
gram from the sizes shown.
170
D Make sure that [Vertical] is se-
lected.
Note
r If [Vertical] has not been se-
lected, press [Vertical].
E Enter the vertical size of the pa-
per using the number keys,
and then press [#].
Note
r You can specify a vertical
size from 210 mm (8.3 inch)
to 305 mm (12.0 inch). You
cannot enter a size smaller
than 210 mm or larger than
305 mm.
r Each time you press [mm] or
[inch], the units switch be-
tween "mm" and "inch". If
y o u e n t e r a l e n g t h a n d
change the units by pressing
[mm] or [inch], it is converted
automatically (fractions are
rounded off).
F Enter the horizontal size of the
paper using the number keys,
and then press [#].