Lacp Agg Standby - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

Link Aggregation Commands

lacp agg standby

Configures the standby status for a switch port. When this status is enabled, the port is eligible to partici-
pate in a dual-home link aggregate as a standby port.
lacp agg [ethernet | fastethernet | gigaethernet] slot/port standby {enable | disable}
Syntax Definitions
ethernet
fastethernet
gigaethernet
slot
port
Defaults
By default, the standby functionality is disabled on a switch port.
Platforms Supported
OmniSwitch 6400, 6850, 6850E, 6855, 9000E
Usage Guidelines
•
A dual home link aggregate consists of one active primary port and one standby port. Enabling the
standby status makes a port eligible to serve as the standby port in this type of aggregate. Use this
command to enable the standby status before the port is associated with the link aggregate.
•
The ethernet, fastethernet, and gigaethernet keywords do not modify a port's configuration. See
Chapter 1, "Ethernet Port Commands,"
Examples
-> lacp agg 2/1 standby enable
-> lacp agg 2/1 standby disable
Release History
Release 6.4.3; command was introduced.
OmniSwitch CLI Reference Guide
Documents that the port is 10 Mbps Ethernet.
Documents that the port is 100 Mbps Fast Ethernet.
Documents that the port is Gigabit Ethernet.
The slot number for the standby port.
The port number for the standby port.
for information on CLI commands to configure Ethernet ports.
June 2012 page 8-45