Mvrp Port - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

MVRP Commands

mvrp port

Enables or disables MVRP on specific ports on the switch.
mvrp port slot/port [– port2] {enable | disable}
Syntax Definitions
slot/port
enable
disable
Defaults
By default, mvrp is disabled on all the ports.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
MVRP can be enabled on switch ports regardless of whether it is globally enabled on the switch.
However, for the port to become an active participant in the MVRP operation, MVRP should be
enabled globally on the switch.
•
When MVRP is globally enabled on the switch and is not enabled on the port, that port is excluded
from the MVRP protocol operation.
•
MVRP can be enabled only on fixed ports, 802.1 Q ports, aggregate ports, and VLAN Stacking
Network ports. Other ports (mirroring ports, aggregable ports, mobile ports, VPLS Access ports,
VLAN Stacking User ports) do not support MVRP.
•
MVRP should not be enabled on ERP ring ports.
Examples
-> mvrp port 1/2 enable
-> mvrp port 1/2 disable
-> mvrp port 1/1-10 enable
-> mvrp port 1/1-10 disable
Release History
Release 6.4.3; command was introduced.
OmniSwitch CLI Reference Guide
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
Enables MVRP on a port.
Disables MVRP on a port.
June 2012 page 11-5