Gvrp Registration - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

GVRP Commands

gvrp registration

Configures the GVRP registration mode for a specific port or an aggregate of ports.
gvrp registration {normal | fixed | forbidden} {linkagg agg_num | port slot/port}
no gvrp registration {linkagg agg_num | port slot/port}
Syntax Definitions
normal
fixed
forbidden
agg_num
slot/port
Defaults
parameter
normal | fixed | forbidden
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to set the registration mode to the default value.
•
GVRP should be enabled on the port before configuring the GVRP registration mode.
•
The registration mode for the default VLANs of all the ports in the switch will be set to fixed.
•
To use the agg_num parameter, the link aggregate group should be created and enabled.
Examples
-> gvrp registration forbidden port 3/2
-> no gvrp registration port 3/2
Release History
Release 6.2.1; command was introduced.
OmniSwitch CLI Reference Guide
Specifies that both registration and de-registration of VLANs are
allowed. VLANs can be mapped either dynamically (through GVRP) or
statically (through management application) on such a port.
Specifies that only static mapping of VLANs is allowed on the port but
de-registration of previously created dynamic or static VLANs is not
allowed.
Specifies that dynamic VLAN registration or de-registration is not
allowed on the port. Any dynamic VLAN created earlier will be de-
registered.
The number corresponding to the aggregate group.
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
default
normal
June 2012 page 10-7