Mvrp Static-Vlan-Restrict - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

mvrp static-vlan-restrict

Restricts a port from becoming a member of a statically created VLAN or a range of VLANs.
mvrp {linkagg agg_num [-agg_num2] | port slot/port [– port2]} static-vlan-restrict vlan vlan-list
no mvrp {linkagg agg_num [-agg_num2] | port slot/port [– port2]} static-vlan-restrict vlan vlan-list
Syntax Definitions
agg_num
slot/port
vlan_list
Defaults
By default, ports are assigned to the static VLAN based on MVRP PDU processing.
Platforms Supported
OmniSwitch 6400, 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command applies only to static VLANs and does not apply to dynamic VLANs.
•
Use the no form of this command to set the specified port and VLAN to the default value.
•
Use the agg_num or slot/port parameter with this command to display GVRP statistics for a specific
port.
Examples
-> mvrp port 1/2 static-vlan-restrict vlan 5
-> no mvrp port 1/2 static-vlan-restrict vlan 5
-> mvrp port 1/2 static-vlan-restrict vlan 6-9
-> no mvrp port 1/2 static-vlan-restrict vlan 6-9
-> mvrp linkagg 3 static-vlan-restrict vlan 4-5
-> no mvrp linkagg 3 static-vlan-restrict aggregate vlan 4-5
Release History
Release 6.4.3; command was introduced.
page 11-28
The number corresponding to the aggregate group.
The slot number for the module and the physical port number on that
module (e.g., 3/1 specifies port 1 on slot 3).
The list of VLAN IDs or the VLAN ID range (e.g., 1-10).
OmniSwitch CLI Reference Guide
MVRP Commands
June 2012